Frigidaire Oven Repair Cost in Edmonton (2026)
Frigidaire oven repairs in Edmonton cost $110-$360 CAD. Frigidaire parts are among the most affordable available, making oven repairs cost-effective even on older Gallery Series models.
| Repair | Cost (CAD) |
|---|---|
| Diagnostic / Service Call | $85-$100 |
| Temperature sensor (F30/F31) | $110-$200 |
| Door latch assembly (F90) | $130-$240 |
| Bake element replacement | $100,-$200 |
| Broil element replacement | $100-$190 |
| Gas igniter replacement | $130-$240 |
| Control board (relay board) | $190-$340 |
Prices are estimates. Diagnostic fee applied toward repair. For Frigidaire brand information, see our Frigidaire appliance repair page. For general oven repair, see our oven repair Edmonton page.
Common Frigidaire Oven Problems and Error Codes
Frigidaire ovens use an F-code error system with codes specific to the Electrolux/Frigidaire platform:
F10 — Runaway Temperature: The oven is detecting or commanding temperatures far beyond the set point. This is a critical safety error — shut off the oven immediately if F10 appears. The temperature sensor or relay control board is at fault. Do not operate the oven until this is repaired.
F30 — Upper Oven Sensor Failure: The oven temperature sensor in the upper oven cavity has an open circuit. The sensor probe or its wiring has failed. This is common in Frigidaire double oven models aged 7-10 years.
F31 — Upper Oven Sensor Shorted: The upper oven sensor has developed a short circuit rather than an open circuit. The symptom is similar — incorrect temperature readings and inconsistent baking.
F90 — Door Lock Failure: The door latch assembly cannot lock for the self-clean cycle. This code is specific to Frigidaire and Electrolux-platform ovens and differs from the Whirlpool F5 E2 code despite describing the same fault.
SB — Standby Mode Locked: The oven is stuck in standby mode, usually following a power interruption. Resetting the circuit breaker often clears this. Recurring SB indicates a control board fault.
Frigidaire Gallery and Professional Series models: the Gallery Series uses a relay board for oven temperature control rather than a single main board — when the oven temperature is erratic, the relay board rather than the control board is often the issue.
Experienced technicians. We call back in 15 minutes.
Frigidaire Oven Models We Service in Edmonton
We service all Frigidaire oven and range models in Edmonton, including the FGEH3047 and FGEF3055 Gallery electric range series, the FGGF3047 and FGGF3059 Gallery gas range series, the FGET2745 and FGET3066 Gallery wall oven series, and the FPEF3077 and FPEF3081 Professional Series ranges. Frigidaire Gallery models sold in Canada between 2010-2020 are the most commonly repaired in Edmonton — they are at the age where control boards and temperature sensors begin to fail.
Why Frigidaire Ovens Need Specialized Repair
Frigidaire Gallery Series ovens use a separate relay control board for oven temperature management in addition to the main electronic control board. When oven temperature is erratic or the oven does not heat to the correct temperature, diagnosing which board is at fault requires testing relay board voltages specifically. Many technicians replace the main control board first — an expensive mistake if the relay board is the actual fault. Our technicians test both boards during any Frigidaire oven temperature diagnostic.